Datamax O'Neil H-8308P Manual del operador descargar pdf (Pagina 34)

6. Select the Paper Sensor Type button until your paper type appears. The options

are as follows:

# Gap

# Mark on Bottom

# Notch

# Continuous

Note: For more information, refer to the section “Top-of-Form Sensor.”

7. Select the Ribbon Mode button until the correct option appears. The options are as

follows:

# None

# Coated In (CSI)

# Coated Out (CSO)

Note: For more information, refer to the section “Top-of-Form Sensor.”

Note: CSI ribbon (shiny side facing outward) should be installed where the ribbon unwinds in

a counterclockwise direction. CSO ribbon (dull side facing outward) should be installed where

the ribbon unwinds in a clockwise direction. If these settings do not match the ribbon type

being used, the ribbon supply hub will turn in the wrong direction.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 115 116

Sin comentarios

Datamax O'Neil H-8308P Manual del operador Pagina 34