
S-Class 45
Standard Media Sensor option –
Using a soft-bristled brush or compressed air, sweep or direct an air
stream into the Media Sensor to remove any debris. (In cases of
extreme build-up, a cotton swab dampened
isopropyl alcohol can be
used to wipe off the sensor; however, if this method is used, allow
the sensor to dry before proceeding.)
Printhead Assembly
Media Sensor
Cotton Swab
Lower the printhead assembly and slide the printhead latch into the
‘locked’ position.
Plug in and turn ‘On’ the printer. Load ticket stock; see Section 3.2.
ST Models: Close the access cover. This completes the procedure.
Comentarios a estos manuales