Datamax-oneil S-Class User Guide Manual de usuario descargar pdf (Pagina 47)

S-Class 39

4.3.1 Database Modification Example

This section details the modification of an Operational Database

parameter. The following example increases the printing speed parameter

from 6 to 8 IPS on the ST-3210; however, using the same basic

procedure, any of the parameters can be changed regardless of the printer

model.

 If on-line, press the PAUSE button to place the printer off-line.

 Press and hold the F2 button until the On-Line Indicator is lit

(approximately six seconds) then release.

The printer will turn off the

On-Line Indicator and

print:

STOCK ID = 5

 Press the F2 button three times (allow time for printing following

each button press), to arrive at the Print Speed parameter.

The printer will print:

PRINT SPEED = 6 IPS

PARSER MODE = AUTO

TICKET WIDTH = 189 (48 MM)

STOCK ID = 5

 Press the F1 button two times (again, allow time for printing

following each button press), to arrive at the 8 IPS setting.

The printer will print:

PRINT SPEED = 8 IPS

PRINT SPEED = 7 IPS

PRINT SPEED = 6 IPS

PARSER MODE = AUTO

TICKET WIDTH = 189 (48 MM)

STOCK ID = 5

 To save the changes and exit the mode, press and hold the F2 button

until the On-Line Indicator is lit (approximately six seconds) then

release.

The parameter changes can be confirmed by printing a Configuration

Ticket; see Section 3.5.1.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

Sin comentarios

Datamax-oneil S-Class User Guide Manual de usuario Pagina 47