Datamax-oneil Performance series Thermal Transfer Manual de usuario Pagina 1

Thermal Transfer Installation Guide | 29 Thermal Transfer Installation Guide11. Route the cable where it will not be damaged during the ribbon tr

2 | Thermal Transfer Installation GuideThermal Transfer Installation Guide 1014.Insert the ribbon hub and the ribbon rewind hub through the ribbon

Thermal Transfer Installation Guide | 211 Thermal Transfer Installation Guide15.Install both (2) gears, both (2) wave washers and both (2) e-clip

2 | Thermal Transfer Installation GuideThermal Transfer Installation Guide 1216.Using the supplied screw, install the power ribbon transport cover

1 Media Hub Installation Guide1 Safety Warnings and CautionsThe following Warnings and Cautions are used throughout this manual:Warning: Warnings aler

3 Thermal Transfer Installation Guide2 Thermal Transfer Installation GuideTools Needed• 2.5mm Hex Head Wrench• 5mm Hex Head Wrench• 7mm Nut Driver• #1

2 | Thermal Transfer Installation GuideThermal Transfer Installation Guide 4Thermal Transfer Installation ProcedureNote: Retain all hardware for r

Thermal Transfer Installation Guide | 25 Thermal Transfer Installation Guide3. Remove all four 7mm nuts securing the present sensor cable connect

2 | Thermal Transfer Installation GuideThermal Transfer Installation Guide 66. Loosen and remove the three (3) 2.5mm hex head screws securing the

Thermal Transfer Installation Guide | 27 Thermal Transfer Installation Guide8. Remove both (2) frame plugs.Figure: 2 - 6 Frame Plugs

2 | Thermal Transfer Installation GuideThermal Transfer Installation Guide 89. Secure the ribbon spool cover to the printer frame with both (2) sc