Datamax-oneil Performance series Internal Rewinder Manual de usuario

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 810.Secure the media rewinder assembly to the printer frame by installi

Internal Rewind Installation Guide | 29 Internal Rewinder Installation Guide12.Insert the media rewind hub through the printer frame and through t

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 1013.Install the supplied helical gear to the media rewind hub and secu

Internal Rewind Installation Guide | 211 Internal Rewinder Installation Guide14.Place the rewinder assembly cover over the rewinder and secure it

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 1216.Insert a small, flat-blade screwdriver into the release opening, g

Internal Rewind Installation Guide | 213 Internal Rewinder Installation Guide17.Loosen and remove the screw securing the platen cover to the plate

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 1418.Insert the lower platen roller assembly through the opening in the

Internal Rewind Installation Guide | 215 Internal Rewinder Installation Guide19.Install the flanged bearing and secure it with the e-clip.Figure:

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 1620.If applicable, loosen and remove the thumbscrew securing the tear

1 Internal Rewinder Installation Guide1 Safety Warnings and CautionsThe following Warnings and Cautions are used throughout this manual:Warning: Warni

1 | SafetyInternal Rewinder Installation Guide 2

3 Internal Rewinder Installation Guide2 Internal Rewind Installation GuideTools Needed• 2.5mm Hex Head Wrench• 3mm Hex Head Wrench• 5mm Hex Head Wrenc

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 4Internal Rewinder Installation ProcedureNote: Retain all hardware for

Internal Rewind Installation Guide | 25 Internal Rewinder Installation Guide3. Remove all four 7mm nuts securing the present sensor cable connecti

2 | Internal Rewind Installation GuideInternal Rewinder Installation Guide 66. Loosen and remove the three (3) 2.5mm hex head screws securing the

Internal Rewind Installation Guide | 27 Internal Rewinder Installation Guide8. Remove the frame plug from the side of the printer.Figure: 2 - 6 Fr