Datamax-oneil Performance series Wireless Manual de usuario

Wireless Installation Instructions | 17 Wireless Installation Guide9. Insert the foam strip directly behind the wireless module sub-assembly on t

1 | Wireless Installation InstructionsWireless Installation Guide 810.Carefully remove the frame plug from the back of the printer.Figure: 1 - 9 F

Wireless Installation Instructions | 19 Wireless Installation Guide11. Insert the cable assembly through the frame and secure it with the include

1 | Wireless Installation InstructionsWireless Installation Guide 10Caution: Any pressure exerted on the wireless module sub-assembly could damage

Wireless Installation Instructions | 111 Wireless Installation Guide13.Install the antenna on the cable assembly and secure it by tightening the

1 | Wireless Installation InstructionsWireless Installation Guide 1214.Apply the FCC ID label just above the antenna base.Figure: 1 - 13 FCC ID La

1 Wireless Installation Guide1 Safety Warnings and CautionsThe following Warnings and Cautions are used throughout this manual:Warning: Warnings alert

1 Wireless Installation Guide1 Wireless Installation InstructionsFigure: 1 - 1 Wireless OptionTable 1: Wireless AssemblyTools Needed• 2.5mm Hex Head W

1 | Wireless Installation InstructionsWireless Installation Guide 2Safety OverviewCaution: ESD protection is required when performing these steps.

Wireless Installation Instructions | 13 Wireless Installation GuideWireless Installation Procedure Note: Retain all hardware for reassembly.1. Op

1 | Wireless Installation InstructionsWireless Installation Guide 43. Remove all four 7mm nuts securing the present sensor cable connection cover

Wireless Installation Instructions | 15 Wireless Installation Guide6. Loosen and remove the three (3) 2.5mm hex head screws securing the right si

1 | Wireless Installation InstructionsWireless Installation Guide 6Note: Once it is fully inserted, it should click into place.Figure: 1 - 7 Wirel