Datamax-oneil OC-3 SERIES User Guide Manual de usuario descargar pdf (Pagina 8)

OC-3 SERIES OF PRINTERS USER'S GUIDE

Note: Do not force the battery into the battery cavity. When

inserted properly, the battery easily slides and locks into

place. If the battery does not easily slide into place, re-

insert the battery.

6. Close the printer cover (Figure 13).

7. Charge the battery (batteries are shipped uncharged). For

more information, see "Charging the battery" on page 4.

Removing the battery

1. Lift the battery up and out of the battery cavity while sliding

it to the left (Figure 14).

2. Remove the battery from the battery cavity (Figure 15).

Charging the battery

The battery status LED will glow red if the battery charge is low

and the printer is powered on. (For more information, see

"Using the control panel" on page 13.)

Charge the battery as follows:

1. Verify the battery is installed correctly.

Figure 13Figure 11 Figure 12

Figure 14

Figure 15

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Datamax-oneil OC-3 SERIES User Guide Manual de usuario Pagina 8