Datamax-oneil Labelpoint Programmer’s Manual Manual de usuario descargar pdf (Pagina 59)

PROGRAMMER’S REFERENCE MANUAL

Document commands

Page 55

Cutter mode

When the printer is switched on, the cutter operates in automatic mode, that is, after each

print-out a cut is executed. The automatic mode can be turned off by the command:

!D T M

To turn automatic cutting on again, send the command:

!D T A

Cutting command

To execute a cut when in manual cutting mode, send the command:

!D T T

(For backwards compatibility with Mk2 printers, the old cut command, !T, can be used.)

Label-taken sensor (LTS)

When the optional LTS is installed it is active by default, that is, after each print-out the

printer waits for the label to be taken before it continues with the next print-out. The LTS can

be turned off by the command:

!D L 0

To turn the LTS on again, send the command:

!D L 1

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 94 95

Sin comentarios

Datamax-oneil Labelpoint Programmer’s Manual Manual de usuario Pagina 59