Datamax-oneil PrintPAD series OF PRINTERS User Guide Manual de usuario descargar pdf (Pagina 12)

PRINTPAD SERIES OF PRINTERS USER'S GUIDE

Using PrintPAD Charge LEDs

Using Batteries

1. Open the printer by unsnapping the latch on the

front of the case.

2. Remove the batteries by pressing the retainer clip

outward with your thumb. While pressing the

retainer clip, lift the outside end of the battery past

the retainer clip (Figure 12).

3. Insert the new batteries. Verify the battery contacts

are facing down and are facing the outside edge of

the printer (Figure 13).

Charge LED State of Charge Action

Solid red Charge in progress. Wait for green LED.

Green Charge completed. None.

Red flash-slow Battery is too cold.

Battery is disconnected.

Change environment.

Connect battery.

Red flash-fast High temperature. Change environment.

Red/orange

flash-slow

Battery voltage is very

low.

Wait for solid red.

Restart charge.

Red/orange

flash-fast

Battery is disconnected. Connect battery.

Orange flash-

slow

Charge timeout. Restart charge.

Contacts

Edge of

printer

Figure 12 Figure 13

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Datamax-oneil PrintPAD series OF PRINTERS User Guide Manual de usuario Pagina 12