Datamax-oneil S-Class SV Cutter Option Manual de usuario

SV Cutter Option92-2415-01 Rev.D

8 8. Connect P1 of the Cutter Assembly to J2 of the Cutter CCA, and then secure the connection using two Screws (Item 6). There are two cutter cab

9 10. Replace the electronics cover and secure it using the two previously removed screws. Proceed to Step C, below. Step C: Adjusting the Front

10 Cutter Maintenance Cutter maintenance is recommended after every 5,000 − 10,000 cuts, an interval that varies depending upon the type of ti

11 5. Unlock and raise the printhead. While supporting the Cutter Assembly, remove the two Mounting Screws, and then carefully slide the Cutter Ass

12 9. Reconnect P1 to the Cutter CCA and secure it with the two previously removed screws. Cutter CCAScrewsP1 10. Replace the electronics c

13 Cutting Requirements Table 1, below, lists the media requirements for use in the cutter mechanism. For a complete listing of these requiremen

1 Contents of this Cutter Kit This kit contains the following items:  Cutter Assembly  Cutter Circuit Card Assembly  Front Plate Assemb

2 5. Remove the two Screws that secure the Electronics Cover to the printer. 6. Grasp the Electronics Cover from bottom and, while pulling do

3 8. Remove the two Screws that secure the Cover Plate and then remove the plate. Cover PlateScrews 9. Remove the two Screws that secure t

4 10. Remove the four Nuts that secure the Front Plate Assembly to the printer and then remove the assembly. Proceed to Step B of this procedure.

5 2. Replace the Power Supply Cover by inserting the Tabs into the Slots in the frame, and then secure the cover using the two previously removed S

6 4. Carefully slide the Cutter Assembly (Item 1) into the printer. Ensure that the Guide Pins on the assembly fit into the Locator Holes in the pr

7 6. Install the Cutter CCA (Item 2) into the printer by placing the Tab into the Locator Hole in the Baseplate. Cutter CCATabBaseplateLocator H