Datamax-oneil S2000i User Guide Manual de usuario descargar pdf (Pagina 14)

FIGURE 4 – Serial Connector

5.3 RS232 Communication Interface - General Notes & DIP Switch

Settings

 Eight-position dip switch, located to one side of the paper roll, is used to select and set the serial RS232

interface. The printer reads these switches once, on initial power-up. The functions assigned to each

switch are listed in Table 2.

 Proper Baud Rate and protocol settings are required to communicate with a host computer. The standard

factory setting is 19,200 BAUD, 8 DATA BITS, NO PARITY BIT, and one STOP BIT, all switches in

off position.

TABLE 2 - DIP switch settings

Dip Switch Function

1 & 2 Baud rate SW1 SW2

Standard Baud rate

38,400 Off Off

19,200 On Off

9,600 Off On

4,800 On On

3 No. of data bits SW3

7 Data Bits on

8 Data bits Off

4 & 5 Parity bit SW4 SW5

Serial RS232 mode

No Parity off off

Odd Parity on off

No Parity Off 0n

Even Parity on on

6 Bluetooth Communication SW6

Enable On

Disable Off

7 Reserved SW7 Reserved

8 Communication Interface SW8

RS232 Off

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sin comentarios

Datamax-oneil S2000i User Guide Manual de usuario Pagina 14