Datamax-oneil H-Class Linear Scanner Option Manual de usuario Pagina 1

Linear Scanner Option 92-2435-01 Rev.C

8 Configuration A printer equipped with the Linear Scanner arrives with these default settings: Menu Location Function and Default Setting PRINTER

9 Scanner Menu Item Description MODE Sets device power-up detection: ENABLED Detection is performed: If found, normal printing and scanning occurs;

10 Scanner Menu Item Description REDUNDANCY LEVEL Ensures bar code integrity by specifying a redundant read count. (1X – 6X) READ BARCODE 2X This

11 Fault Handling Menu Item Description DELAYED SCAN FAULT Increases throughput when bar codes reside near the trailing edge (in the print directio

12 A - Is the device type: S = Linear Scanner B - Is the resulting status: C = entire label complete; F = faulted (failed) label; and, U = unkno

13 Alignment Although normally not required if factory-installed, scanner alignment may be necessary under certain circumstances:  If the scann

14 Picket FenceBar CodeScannerPrintheadAssemblyLED  Note: Ensure that the Scanner is enabled in the following steps. 5) Press MENU. Press DO

15 8) Slightly raise the Pivoting Mount. Loosen the Locking Screws and the Mounting Adjustment Screw enough to allow the Scanner to be positioned. Ca

16 10) Proceed according to the Scan Position: 10-Mil Position: Carefully tighten the Mounting Adjustment Screw. MountingAdjustment Screw 5-Mil P

17 11) Proceed according to the Scan Position: 10-Mil Position: Carefully raise the Pivoting Mount and then tighten the Locking Screw. Carefully lo

18 12) Proceed according to the Scan Position: 10-Mil Position: Loosen the Thumbscrew and slide the Scanner to the rightmost position on the Mounti

19 Scan Resolutions Capable of scanning 5- or 10-mil symbologies, the scan resolution is determined by the Linear Scanner’s height above the label su

20 Troubleshooting Use the table below to locate a description of the symptom that best fits the problem and then find a corresponding solution.

21 Problem Possible solution… Scanner Faults are generated when scanning.  Note: • Faults are normal when a bar code has defects, includi

22 Specifications Physical Case Material Steel (Black) Dimensions (L x H x W) 47 x 20 x 55 mm (1.95 x 0.78 x 2.2 in) Cable Length 7.0 inches wi

23 Warranty Information Warranty Service Procedures Datamax-O’Neil warrants to Purchaser that under normal use and service, the Scanner purchased he

1 Overview With the H-Class Linear Scanner option and menu-selectable functions that include voiding and replacement generation, labels can be interr

2 1) Turn OFF the Power Switch and unplug the power cord from the AC Receptacle. AC ReceptaclePower Switch 2) Press down on the Catch, then p

3 4) Remove the Plug from the Center Plate Aperture. Center PlateAperturePlug 5) Secure the mini-din connector of the Cable Assembly (Item 5)

4 7) Secure the Scanner and Mounting Assembly (Item 1) to the Center Plate using three Screws (Item 2). ScrewsScanner andMounting AssemblyCenter Pl

5 10) Press the Tabs of the Lens together. Then slide the Lens off the Fascia. (Store the Lens in a safe place, for future use.) LensFasciaTabs

6 Controls and Features, Performance, and Configuration This section includes topics on operations. Controls and Features Item Function Location

7 Integrity and Speed  If the primary objective is to ensure that correct data is read over a significant region of the symbology, maximize integr