Datamax-oneil H-Class GPIO Option Manual de usuario

GPIO Option 92-2427-01 Rev.C

8 ► COM C (J4) Recognized by the printer as Serial Port C, COM C functions as an auxiliary RS-232 interface or dedicated device port for the RFID

9 Step 2: Installing the Option Install the GPIO Card as described below: AC ReceptaclePower Switch Back PanelScrewsCard Cage A) Tu

10 D) Place the Cover Plate (Item 2) onto the Card Cage, as shown, then install and tighten the two Screws (Item 3) to secure the plate. Cover

11 Step 4: Configuring the Software Settings Configure the printer’s menu settings for the option’s operation. A) Using the Control Panel, e

12 GPIO A Signals GPIO A Signals GPIO B Signals GPIO B Signals  Input Monitor – Display incoming GPIO binary signal states using the ADVANCED MENU

1 Overview This document describes the installation and use of the General Purpose Input Output (GPIO) option for the H-Class printer. After veri

2 COM C RS-232 Cables Part # 32-2300-01 Part # 32-2301-01 COM D RS-232 Cable Host DB-9S Printer RJ45P 1RXDTXD+5 VDCGROUNDTXD

3 Step 1: Configuring the Hardware Configure the card to meet your interfacing requirements by arranging hardware jumpers, as described in the f

4 For direct inputs – Use the printer’s +5VDC and Ground to supply the devices interfacing to the GPI/O A inputs (as shown in the sample circuit,

5 WARNING Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices. GPI/O Port A Jumper Overvi

6 ► GPI/O B (J2) Six unassigned inputs are designed to interface to open-collector outputs. These inputs require no external pull-ups, while bloc

7 WARNING Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices. GPI/O Port B Overview Pin