Datamax-oneil APEX Series Programmer’s Manual Manual de usuario descargar pdf (Pagina 60)

RS232C Technical Specifications

Name Value

Data Transfer Rate 1200 – 115200 Baud

Word Length 10 or 11 bits

Start Bit 1

Data Bits 8

Parity Bit None, Odd or Even

Stop Bits Auto Select 1 or 2

Signal Levels RS232C

Mark or Logical 1 -3 to -15 VDC

Space or Logical 0 + 3 to + 15 VDC

Handshaking Two modes are supported (Software and Hardware)

Hardware RTS/CTS

Software XON/XOFF

Auto Power Up Positive Signal on RTS input switches the printer ON

USB Communication (USB)

Overview

Apex printer comes equipped with a USB 2.0 slave port. Everything that can be done through the RS-232 port can now

be done through the USB port, using A to B type USB cable. You may print to or send commands to the printer from a

PC or any equipment that can act as a USB master.

Dip switch setting

To enable USB, you must set the dipswitches on the printer as below:

SW 1 SW 2 SW 3 SW 4 SW 5 SW 6 SW 7 SW 8

Any

position

Any

position

Any

position

Any

position

Any

position

Off On Any

position

Compatible Software

The host and printer communicate through a method called the "Virtual Com Port", in which a software intermediary called the

"driver" makes the USB connection look like a com port to the end-application. Consequently, all software that communicates

through the com port is compatible. You may continue to use legacy software, such as the TeraTerm terminal emulation

software.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67

Sin comentarios

Datamax-oneil APEX Series Programmer’s Manual Manual de usuario Pagina 60